Let’s talk about the 660mm Carbon Infrared Heater
If you’re looking for a way to get heat deeper into your materials, you might want to look at our 660mm clear carbon lamp. Most people are used to those standard quartz halogen tubes, but we went with a carbon filament here. It completely changes the way the heat actually hits your workpiece. The Power Side of Things It runs at 220V and pulls 1000W. Because it’s 660mm long, the heat spreads out evenly. You won’t have to deal with those annoying hot spots that can ruin a project. Just a heads-up: keep your power supply steady. If your voltage is jumping all over the place, you’re going to fry the filament way sooner than you should. Keep it stable, and it’ll last. Why Carbon? We use a clear quartz envelope so the heat can move freely. Now, carbon filaments don’t get as scorching hot as tungsten, but they’re better at pumping out medium-wave infrared. Here’s why that matters: the heat actually penetrates deeper into coatings or plastics. Plus, if you’ve got an old oven, these usually slide right into the existing footprint without a fuss. Real-World Use You’ll mostly see these in PET blowing, paint curing, or drying tunnels. They’re perfect for materials that just “soak up” these specific wavelengths. But there’s a catch. Carbon lamps don’t snap on instantly like short-wave halogens do. They need a moment to warm up. If your process depends on millisecond timing, this isn’t your tool. But for steady drying and curing? It’s great. One last thing—keep your reflectors clean. A bit of dust on the quartz might seem harmless, but it kills your efficiency and can actually pop the tube. Give them a wipe. Your equipment will thank you.